drivers: pci: imx: add imx_pcie_remove function
There is no dedicated reset signal wired up for the MX6QDL thus if the
bootloader enables the link we need some special handling to get the core
back into a state where it is safe to touch it for configuration.
While there has been some special handling in the Linux kernel to do this,
it was removed in 4.11 thus we need to do it properly in the bootloader
and therefore without this if you enable PCI in the bootloader you will hang
while booting the 4.11 kernel.
This puts the PCIe controller back into a safe state for the kernel driver
before launching the kernel.
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>
Tested-by: Peter Senna Tschudin <peter.senna@collabora.com>
diff --git a/arch/arm/imx-common/cpu.c b/arch/arm/imx-common/cpu.c
index 40fe813..74bdd24 100644
--- a/arch/arm/imx-common/cpu.c
+++ b/arch/arm/imx-common/cpu.c
@@ -275,6 +275,9 @@
void arch_preboot_os(void)
{
+#if defined(CONFIG_PCIE_IMX)
+ imx_pcie_remove();
+#endif
#if defined(CONFIG_CMD_SATA)
sata_stop();
#if defined(CONFIG_MX6)