diff --git a/drivers/pinctrl/pinctrl-zynqmp.c b/drivers/pinctrl/pinctrl-zynqmp.c
index 7c5a02d..ee6529b 100644
--- a/drivers/pinctrl/pinctrl-zynqmp.c
+++ b/drivers/pinctrl/pinctrl-zynqmp.c
@@ -73,7 +73,7 @@
 
 /**
  * enum zynqmp_pin_config_param - possible pin configuration parameters
- * @PIN_CONFIG_IOSTANDARD:	if the pin can select an IO standard,
+ * @PIN_CFG_IOSTANDARD:	if the pin can select an IO standard,
  *				the argument to this parameter (on a
  *				custom format) tells the driver which
  *				alternative IO standard to use
@@ -81,7 +81,7 @@
  *				to select schmitt or cmos input for MIO pins
  */
 enum zynqmp_pin_config_param {
-	PIN_CONFIG_IOSTANDARD = PIN_CONFIG_END + 1,
+	PIN_CFG_IOSTANDARD = PIN_CONFIG_END + 1,
 	PIN_CONFIG_SCHMITTCMOS,
 };
 
@@ -452,7 +452,7 @@
 		param = PM_PINCTRL_CONFIG_DRIVE_STRENGTH;
 		ret = zynqmp_pm_pinctrl_set_config(pin, param, value);
 		break;
-	case PIN_CONFIG_IOSTANDARD:
+	case PIN_CFG_IOSTANDARD:
 		param = PM_PINCTRL_CONFIG_VOLTAGE_STATUS;
 		ret = zynqmp_pm_pinctrl_get_config(pin, param, &value);
 		if (arg != value)
@@ -608,7 +608,7 @@
 	{ "slew-rate", PIN_CONFIG_SLEW_RATE, 0 },
 	{ "skew-delay", PIN_CONFIG_SKEW_DELAY, 0 },
 	/* zynqmp specific */
-	{"io-standard", PIN_CONFIG_IOSTANDARD, IO_STANDARD_LVCMOS18},
+	{"io-standard", PIN_CFG_IOSTANDARD, IO_STANDARD_LVCMOS18},
 	{"schmitt-cmos", PIN_CONFIG_SCHMITTCMOS, PM_PINCTRL_INPUT_TYPE_SCHMITT},
 };