clk: Allow force setting clock defaults before relocation
Since 291da96b8e ("clk: Allow clock defaults to be set during re-reloc
state for SPL only") it has been impossible to set clock defaults before
relocation. This is annoying on boards without SPL, since there is no way
to set clock defaults before U-Boot proper. In particular, the aisram rate
must be changed before relocation on the K210, since U-Boot will hang if we
try and change the rate while we are using aisram.
To get around this, extend the stage parameter to allow force setting
defaults, even if they would be otherwise postponed for later. A device
tree property was decided against because of the concerns in the original
commit thread about the overhead of repeatedly parsing the device tree.
Signed-off-by: Sean Anderson <seanga2@gmail.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
diff --git a/include/clk.h b/include/clk.h
index ca6b85f..f3c88fe 100644
--- a/include/clk.h
+++ b/include/clk.h
@@ -277,19 +277,41 @@
}
#endif
+/**
+ * enum clk_defaults_stage - What stage clk_set_defaults() is called at
+ * @CLK_DEFAULTS_PRE: Called before probe. Setting of defaults for clocks owned
+ * by this clock driver will be defered until after probing.
+ * @CLK_DEFAULTS_POST: Called after probe. Only defaults for clocks owned by
+ * this clock driver will be set.
+ * @CLK_DEFAULTS_POST_FORCE: Called after probe, and always set defaults, even
+ * before relocation. Usually, defaults are not set
+ * pre-relocation to avoid setting them twice (when
+ * the device is probed again post-relocation). This
+ * may incur a performance cost as device tree
+ * properties must be parsed for a second time.
+ * However, when not using SPL, pre-relocation may be
+ * the only time we can set defaults for some clocks
+ * (such as those used for the RAM we will relocate
+ * into).
+ */
+enum clk_defaults_stage {
+ CLK_DEFAULTS_PRE = 0,
+ CLK_DEFAULTS_POST = 1,
+ CLK_DEFAULTS_POST_FORCE,
+};
+
#if (CONFIG_IS_ENABLED(OF_CONTROL) && !CONFIG_IS_ENABLED(OF_PLATDATA)) && \
CONFIG_IS_ENABLED(CLK)
+
/**
* clk_set_defaults - Process 'assigned-{clocks/clock-parents/clock-rates}'
* properties to configure clocks
*
* @dev: A device to process (the ofnode associated with this device
* will be processed).
- * @stage: A integer. 0 indicates that this is called before the device
- * is probed. 1 indicates that this is called just after the
- * device has been probed
+ * @stage: The stage of the probing process this function is called during.
*/
-int clk_set_defaults(struct udevice *dev, int stage);
+int clk_set_defaults(struct udevice *dev, enum clk_defaults_stage stage);
#else
static inline int clk_set_defaults(struct udevice *dev, int stage)
{