ARM: keystone: clock: add support for K2E SoCs
For K2E and K2L SoCs clock output from PASS PLL has to be enabled
after NETCP domain and PA module are enabled. So create new function
for that and call it after PA module is enabled.
Signed-off-by: Ivan Khoronzhuk <ivan.khoronzhuk@ti.com>
diff --git a/arch/arm/cpu/armv7/keystone/clock.c b/arch/arm/cpu/armv7/keystone/clock.c
index 47fc893..d13fbc1 100644
--- a/arch/arm/cpu/armv7/keystone/clock.c
+++ b/arch/arm/cpu/armv7/keystone/clock.c
@@ -185,10 +185,6 @@
tmp &= ~(PLL_BWADJ_HI_MASK);
tmp |= ((bwadj >> 8) & PLL_BWADJ_HI_MASK);
- /* set PLL Select (bit 13) for PASS PLL */
- if (data->pll == PASS_PLL)
- tmp |= PLLCTL_PAPLL;
-
__raw_writel(tmp, keystone_pll_regs[data->pll].reg1);
/* Reset bit: bit 14 for both DDR3 & PASS PLL */
@@ -261,3 +257,16 @@
return get_max_speed((read_efuse_bootrom() >> 16) & 0xffff, arm_speeds);
}
#endif
+
+void pass_pll_pa_clk_enable(void)
+{
+ u32 reg;
+
+ reg = readl(keystone_pll_regs[PASS_PLL].reg1);
+
+ reg |= PLLCTL_PAPLL;
+ writel(reg, keystone_pll_regs[PASS_PLL].reg1);
+
+ /* wait till clock is enabled */
+ sdelay(15000);
+}
diff --git a/arch/arm/include/asm/arch-keystone/clock.h b/arch/arm/include/asm/arch-keystone/clock.h
index 7218230..9f6cfb2 100644
--- a/arch/arm/include/asm/arch-keystone/clock.h
+++ b/arch/arm/include/asm/arch-keystone/clock.h
@@ -58,6 +58,7 @@
unsigned long clk_get_rate(unsigned int clk);
unsigned long clk_round_rate(unsigned int clk, unsigned long hz);
int clk_set_rate(unsigned int clk, unsigned long hz);
+void pass_pll_pa_clk_enable(void);
int get_max_dev_speed(void);
int get_max_arm_speed(void);