Add support for CompactFlash on ATC board
(includes support for Intel 82365 and compatible PC Card controllers,
and Yenta-compatible PCI-to-CardBus controllers)
diff --git a/include/configs/atc.h b/include/configs/atc.h
index 0651ede..4f30847 100644
--- a/include/configs/atc.h
+++ b/include/configs/atc.h
@@ -125,7 +125,12 @@
#define CONFIG_BOOTP_MASK (CONFIG_BOOTP_DEFAULT|CONFIG_BOOTP_BOOTFILESIZE)
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | CFG_CMD_EEPROM)
+#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
+ CFG_CMD_EEPROM | \
+ CFG_CMD_PCI | \
+ CFG_CMD_PCMCIA | \
+ CFG_CMD_IDE)
+#define CONFIG_DOS_PARTITION
/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
#include <cmd_confdefs.h>
@@ -149,6 +154,8 @@
#define CFG_LOAD_ADDR 0x100000 /* default load address */
+#define CFG_PIO_MODE 0 /* IDE interface in PIO Mode 0 */
+
#define CFG_HZ 1000 /* decrementer freq: 1 ms ticks */
#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
@@ -239,6 +246,9 @@
# define CFG_RAMBOOT
#endif
+#define CONFIG_PCI
+#define CONFIG_PCI_PNP
+
#if 1
/* environment is in Flash */
#define CFG_ENV_IS_IN_FLASH 1
@@ -441,4 +451,41 @@
#define CFG_PSDMR CFG_PSDMR_8COL
#endif /* CFG_RAMBOOT */
+/*-----------------------------------------------------------------------
+ * PCMCIA stuff
+ *-----------------------------------------------------------------------
+ *
+ */
+#define CONFIG_I82365
+
+#define CFG_PCMCIA_MEM_ADDR 0x81000000
+#define CFG_PCMCIA_MEM_SIZE 0x1000
+
+/*-----------------------------------------------------------------------
+ * IDE/ATA stuff (Supports IDE harddisk on PCMCIA Adapter)
+ *-----------------------------------------------------------------------
+ */
+
+#define CONFIG_IDE_8xx_PCCARD 1 /* Use IDE with PC Card Adapter */
+
+#undef CONFIG_IDE_8xx_DIRECT /* Direct IDE not supported */
+#undef CONFIG_IDE_LED /* LED for ide not supported */
+#undef CONFIG_IDE_RESET /* reset for ide not supported */
+
+#define CFG_IDE_MAXBUS 1 /* max. 1 IDE bus */
+#define CFG_IDE_MAXDEVICE 1 /* max. 1 drive per IDE bus */
+
+#define CFG_ATA_IDE0_OFFSET 0x0000
+
+#define CFG_ATA_BASE_ADDR 0xa0000000
+
+/* Offset for data I/O */
+#define CFG_ATA_DATA_OFFSET 0x100
+
+/* Offset for normal register accesses */
+#define CFG_ATA_REG_OFFSET 0x100
+
+/* Offset for alternate registers */
+#define CFG_ATA_ALT_OFFSET 0x108
+
#endif /* __CONFIG_H */