at91: Enabeling USB host on meesc board
There was an redesign, so USB is available now.
Signed-off-by: Daniel Gorsulowski <Daniel.Gorsulowski@esd.eu>
Signed-off-by: Reinhard Meyer <u-boot@emk-elektronik.de>
diff --git a/board/esd/meesc/meesc.c b/board/esd/meesc/meesc.c
index 58ef7be..41fa3e1 100644
--- a/board/esd/meesc/meesc.c
+++ b/board/esd/meesc/meesc.c
@@ -253,7 +253,8 @@
/* Peripheral Clock Enable Register */
writel(1 << AT91SAM9263_ID_PIOA |
1 << AT91SAM9263_ID_PIOB |
- 1 << AT91SAM9263_ID_PIOCDE,
+ 1 << AT91SAM9263_ID_PIOCDE |
+ 1 << AT91SAM9263_ID_UHP,
&pmc->pcer);
/* initialize ET1100 Controller */
@@ -275,5 +276,8 @@
#ifdef CONFIG_AT91_CAN
at91_can_hw_init();
#endif
+#ifdef CONFIG_USB_OHCI_NEW
+ at91_uhp_hw_init();
+#endif
return 0;
}
diff --git a/include/configs/meesc.h b/include/configs/meesc.h
index eaea1cd..dbb2531 100644
--- a/include/configs/meesc.h
+++ b/include/configs/meesc.h
@@ -84,11 +84,11 @@
#undef CONFIG_CMD_FPGA
#undef CONFIG_CMD_LOADS
#undef CONFIG_CMD_IMLS
-#undef CONFIG_CMD_USB
#define CONFIG_CMD_PING 1
#define CONFIG_CMD_DHCP 1
#define CONFIG_CMD_NAND 1
+#define CONFIG_CMD_USB 1
/* LED */
#define CONFIG_AT91_LED 1
@@ -132,6 +132,17 @@
#define CONFIG_NET_RETRY_COUNT 20
#undef CONFIG_RESET_PHY_R
+/* USB */
+#define CONFIG_USB_ATMEL
+#define CONFIG_USB_OHCI_NEW 1
+#define CONFIG_DOS_PARTITION 1
+#define CONFIG_SYS_USB_OHCI_CPU_INIT 1
+#define CONFIG_SYS_USB_OHCI_REGS_BASE 0x00a00000
+#define CONFIG_SYS_USB_OHCI_SLOT_NAME "at91sam9263"
+#define CONFIG_SYS_USB_OHCI_MAX_ROOT_PORTS 2
+#define CONFIG_USB_STORAGE 1
+#define CONFIG_CMD_FAT 1
+
#define CONFIG_SYS_LOAD_ADDR 0x22000000 /* load address */
#define CONFIG_SYS_MEMTEST_START PHYS_SDRAM