arm64: zynqmp: Enable booting to ATF
U-Boot is now able to boot to ARM Trusted Firmware (ATF). The boot
flow is SPL(EL3) loads ATF and full u-boot and jump to ATF(EL3) which
pass control to full u-boot(EL2). This has been tested on zcu106, so
enable it in this defconfig.
To generate an image that triggers this booting flow, you need to pass
'-O arm-trusted-firmware' to mkimage.
Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/configs/xilinx_zynqmp_zcu102_revB_defconfig b/configs/xilinx_zynqmp_zcu102_revB_defconfig
index e6530fb..8059255 100644
--- a/configs/xilinx_zynqmp_zcu102_revB_defconfig
+++ b/configs/xilinx_zynqmp_zcu102_revB_defconfig
@@ -19,6 +19,7 @@
CONFIG_SPL_OS_BOOT=y
CONFIG_SPL_RAM_SUPPORT=y
CONFIG_SPL_RAM_DEVICE=y
+CONFIG_SPL_ATF=y
CONFIG_SYS_PROMPT="ZynqMP> "
CONFIG_FASTBOOT=y
CONFIG_FASTBOOT_FLASH=y