powerpc: p1022ds: add TPL for p1022ds nand boot
TPL is introduced in the patch "NAND: TPL : introduce the TPL
based on the SPL", here enable TPL for p1022ds nand boot.
Signed-off-by: Ying Zhang <b40530@freescale.com>
Acked-by: York Sun <yorksun@freescale.com>
diff --git a/drivers/mtd/nand/fsl_elbc_spl.c b/drivers/mtd/nand/fsl_elbc_spl.c
index 7e5599a..a7476b4 100644
--- a/drivers/mtd/nand/fsl_elbc_spl.c
+++ b/drivers/mtd/nand/fsl_elbc_spl.c
@@ -34,7 +34,11 @@
}
}
+#ifdef CONFIG_TPL_BUILD
+int nand_spl_load_image(uint32_t offs, unsigned int uboot_size, void *vdst)
+#else
static int nand_load_image(uint32_t offs, unsigned int uboot_size, void *vdst)
+#endif
{
fsl_lbc_t *regs = LBC_BASE_ADDR;
uchar *buf = (uchar *)CONFIG_SYS_NAND_BASE;
@@ -114,6 +118,15 @@
}
/*
+ * Defines a static function nand_load_image() here, because non-static makes
+ * the code too large for certain SPLs(minimal SPL, maximum size <= 4Kbytes)
+ */
+#ifndef CONFIG_TPL_BUILD
+#define nand_spl_load_image(offs, uboot_size, vdst) \
+ nand_load_image(offs, uboot_size, vdst)
+#endif
+
+/*
* The main entry for NAND booting. It's necessary that SDRAM is already
* configured and available since this code loads the main U-Boot image
* from NAND into SDRAM and starts it from there.
@@ -124,17 +137,17 @@
/*
* Load U-Boot image from NAND into RAM
*/
- nand_load_image(CONFIG_SYS_NAND_U_BOOT_OFFS,
- CONFIG_SYS_NAND_U_BOOT_SIZE,
- (void *)CONFIG_SYS_NAND_U_BOOT_DST);
+ nand_spl_load_image(CONFIG_SYS_NAND_U_BOOT_OFFS,
+ CONFIG_SYS_NAND_U_BOOT_SIZE,
+ (void *)CONFIG_SYS_NAND_U_BOOT_DST);
#ifdef CONFIG_NAND_ENV_DST
- nand_load_image(CONFIG_ENV_OFFSET, CONFIG_ENV_SIZE,
- (void *)CONFIG_NAND_ENV_DST);
+ nand_spl_load_image(CONFIG_ENV_OFFSET, CONFIG_ENV_SIZE,
+ (void *)CONFIG_NAND_ENV_DST);
#ifdef CONFIG_ENV_OFFSET_REDUND
- nand_load_image(CONFIG_ENV_OFFSET_REDUND, CONFIG_ENV_SIZE,
- (void *)CONFIG_NAND_ENV_DST + CONFIG_ENV_SIZE);
+ nand_spl_load_image(CONFIG_ENV_OFFSET_REDUND, CONFIG_ENV_SIZE,
+ (void *)CONFIG_NAND_ENV_DST + CONFIG_ENV_SIZE);
#endif
#endif