usbether: Fixed bug when using with PXA25X chips

PXA25X chips don't support alternate settings so driver uses non-CDC
driver.
But only code defined between DEV_CONFIG_CDC signals that network is up.
This patch is fixing this bug by signaling that network is up after USB
SET_INTERFACE request.

Signed-off-by: Lukasz Dalek <luk0104@gmail.com>
diff --git a/drivers/usb/gadget/ether.c b/drivers/usb/gadget/ether.c
index d975fb6..9ce2c17 100644
--- a/drivers/usb/gadget/ether.c
+++ b/drivers/usb/gadget/ether.c
@@ -44,7 +44,12 @@
 
 unsigned packet_received, packet_sent;
 
-#define DEV_CONFIG_CDC	1
+#ifdef CONFIG_USB_GADGET_PXA2XX
+# undef DEV_CONFIG_CDC
+# define DEV_CONFIG_SUBSET 1
+#else
+# define DEV_CONFIG_CDC	1
+#endif
 #define GFP_ATOMIC ((gfp_t) 0)
 #define GFP_KERNEL ((gfp_t) 0)
 
@@ -864,7 +869,9 @@
 
 /*============================================================================*/
 static u8 control_req[USB_BUFSIZ];
+#if defined(DEV_CONFIG_CDC) || defined(CONFIG_USB_ETH_RNDIS)
 static u8 status_req[STATUS_BYTECOUNT] __attribute__ ((aligned(4)));
+#endif
 
 
 /**
@@ -1352,6 +1359,14 @@
 		if (gadget_is_pxa(gadget)) {
 			value = eth_set_config(dev, DEV_CONFIG_VALUE,
 						GFP_ATOMIC);
+			/*
+			 * PXA25x driver use non-CDC ethernet gadget.
+			 * But only _CDC and _RNDIS code can signalize
+			 * that network is working. So we signalize it
+			 * here.
+			 */
+			l_ethdev.network_started = 1;
+			debug("USB network up!\n");
 			goto done_set_intf;
 		}