ARM: dts: stm32mp1: DT alignment with kernel v5.4
Device tree and binding alignment with kernel v5.4
Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Reviewed-by: Patrice Chotard <patrice.chotard@st.com>
diff --git a/arch/arm/dts/stm32mp157-pinctrl.dtsi b/arch/arm/dts/stm32mp157-pinctrl.dtsi
index 0d53396..07cd080 100644
--- a/arch/arm/dts/stm32mp157-pinctrl.dtsi
+++ b/arch/arm/dts/stm32mp157-pinctrl.dtsi
@@ -622,13 +622,13 @@
<STM32_PINMUX('F', 6, AF9)>; /* QSPI_BK1_IO3 */
bias-disable;
drive-push-pull;
- slew-rate = <3>;
+ slew-rate = <1>;
};
pins2 {
pinmux = <STM32_PINMUX('B', 6, AF10)>; /* QSPI_BK1_NCS */
bias-pull-up;
drive-push-pull;
- slew-rate = <3>;
+ slew-rate = <1>;
};
};
@@ -650,13 +650,13 @@
<STM32_PINMUX('G', 7, AF11)>; /* QSPI_BK2_IO3 */
bias-disable;
drive-push-pull;
- slew-rate = <3>;
+ slew-rate = <1>;
};
pins2 {
pinmux = <STM32_PINMUX('C', 0, AF10)>; /* QSPI_BK2_NCS */
bias-pull-up;
drive-push-pull;
- slew-rate = <3>;
+ slew-rate = <1>;
};
};
diff --git a/arch/arm/dts/stm32mp157c-ev1.dts b/arch/arm/dts/stm32mp157c-ev1.dts
index 89d29b5..aa5892b 100644
--- a/arch/arm/dts/stm32mp157c-ev1.dts
+++ b/arch/arm/dts/stm32mp157c-ev1.dts
@@ -189,8 +189,8 @@
clocks = <&clk_ext_camera>;
clock-names = "xclk";
DOVDD-supply = <&v2v8>;
- powerdown-gpios = <&stmfx_pinctrl 18 GPIO_ACTIVE_HIGH>;
- reset-gpios = <&stmfx_pinctrl 19 GPIO_ACTIVE_LOW>;
+ powerdown-gpios = <&stmfx_pinctrl 18 (GPIO_ACTIVE_HIGH | GPIO_PUSH_PULL)>;
+ reset-gpios = <&stmfx_pinctrl 19 (GPIO_ACTIVE_LOW | GPIO_PUSH_PULL)>;
rotation = <180>;
status = "okay";
@@ -223,7 +223,6 @@
joystick_pins: joystick {
pins = "gpio0", "gpio1", "gpio2", "gpio3", "gpio4";
- drive-push-pull;
bias-pull-down;
};
diff --git a/arch/arm/dts/stm32mp157c.dtsi b/arch/arm/dts/stm32mp157c.dtsi
index 41aea75..28a7e4c 100644
--- a/arch/arm/dts/stm32mp157c.dtsi
+++ b/arch/arm/dts/stm32mp157c.dtsi
@@ -939,7 +939,7 @@
interrupt-names = "int0", "int1";
clocks = <&rcc CK_HSE>, <&rcc FDCAN_K>;
clock-names = "hclk", "cclk";
- bosch,mram-cfg = <0x1400 0 0 32 0 0 2 2>;
+ bosch,mram-cfg = <0x0 0 0 32 0 0 2 2>;
status = "disabled";
};
@@ -952,7 +952,7 @@
interrupt-names = "int0", "int1";
clocks = <&rcc CK_HSE>, <&rcc FDCAN_K>;
clock-names = "hclk", "cclk";
- bosch,mram-cfg = <0x0 0 0 32 0 0 2 2>;
+ bosch,mram-cfg = <0x1400 0 0 32 0 0 2 2>;
status = "disabled";
};
diff --git a/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt b/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt
index 70e76be..ad2bef8 100644
--- a/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt
+++ b/doc/device-tree-bindings/mtd/stm32-fmc2-nand.txt
@@ -18,8 +18,10 @@
- dmas: DMA specifiers (see: dma/stm32-mdma.txt)
- dma-names: Must be "tx", "rx" and "ecc"
-Optional children nodes:
-Children nodes represent the available NAND chips.
+* NAND device bindings:
+
+Required properties:
+- reg: describes the CS lines assigned to the NAND device.
Optional properties:
- nand-on-flash-bbt: see nand.txt