ARM: omap: move board specific NAND configs out from ti_armv7_common.h
This patch moves some board specific NAND configs:
- FROM: generic config file 'ti_armv7_common.h'
- TO: individual board config files using these configs.
So that each board can independently set the value as per its design.
Following configs are affected in this patch:
CONFIG_SYS_NAND_U_BOOT_OFFS: <refer doc/README.nand>
CONFIG_CMD_SPL_NAND_OFS: <refer doc/README.falcon>
CONFIG_SYS_NAND_SPL_KERNEL_OFFS: <refer doc/README.falcon>
CONFIG_CMD_SPL_WRITE_SIZE: <refer doc/README.falcon>
This patch also updates documentation for few of above NAND configs.
Signed-off-by: Pekon Gupta <pekon@ti.com>
diff --git a/doc/README.nand b/doc/README.nand
index 70cf768..e29188f 100644
--- a/doc/README.nand
+++ b/doc/README.nand
@@ -89,6 +89,10 @@
Configuration Options:
+ CONFIG_SYS_NAND_U_BOOT_OFFS
+ NAND Offset from where SPL will read u-boot image. This is the starting
+ address of u-boot MTD partition in NAND.
+
CONFIG_CMD_NAND
Enables NAND support and commmands.
@@ -226,6 +230,14 @@
detection. However ECC calculation on such plaforms would still be
done by GPMC controller.
+ CONFIG_SPL_NAND_AM33XX_BCH
+ Enables SPL-NAND driver (am335x_spl_bch.c) which supports ELM based
+ hardware ECC correction. This is useful for platforms which have ELM
+ hardware engine and use NAND boot mode.
+ Some legacy platforms like OMAP3xx do not have in-built ELM h/w engine,
+ so those platforms should use CONFIG_SPL_NAND_SIMPLE for enabling
+ SPL-NAND driver with software ECC correction support.
+
CONFIG_NAND_OMAP_ECCSCHEME
On OMAP platforms, this CONFIG specifies NAND ECC scheme.
It can take following values: