spl: Set up the bloblist in board_init_r()
At present the bloblist is set up in spl_common_init() which can be called
from spl_early_init(), i.e. before SDRAM is ready. This prevents the
bloblist from being located in SDRAM, which is useful on some platforms
where SRAM is inaccessible after U-Boot relocates (e.g. x86 CAR region).
It doesn't serve much purpose to have the bloblist available early, since
very little is known about the platform then, and the handoff info is
written when SPL is about to jump to U-Boot.
Move the code to board_init_r() to avoid any restrictions.
Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
diff --git a/common/spl/spl.c b/common/spl/spl.c
index 730cd6b..5fdd6d0 100644
--- a/common/spl/spl.c
+++ b/common/spl/spl.c
@@ -410,23 +410,6 @@
return ret;
}
#endif
- if (CONFIG_IS_ENABLED(BLOBLIST)) {
- ret = bloblist_init();
- if (ret) {
- debug("%s: Failed to set up bloblist: ret=%d\n",
- __func__, ret);
- return ret;
- }
- }
- if (CONFIG_IS_ENABLED(HANDOFF)) {
- int ret;
-
- ret = setup_spl_handoff();
- if (ret) {
- puts(SPL_TPL_PROMPT "Cannot set up SPL handoff\n");
- hang();
- }
- }
if (CONFIG_IS_ENABLED(OF_CONTROL) && !CONFIG_IS_ENABLED(OF_PLATDATA)) {
ret = fdtdec_setup();
if (ret) {
@@ -604,6 +587,24 @@
*/
timer_init();
#endif
+ if (CONFIG_IS_ENABLED(BLOBLIST)) {
+ ret = bloblist_init();
+ if (ret) {
+ debug("%s: Failed to set up bloblist: ret=%d\n",
+ __func__, ret);
+ puts(SPL_TPL_PROMPT "Cannot set up bloblist\n");
+ hang();
+ }
+ }
+ if (CONFIG_IS_ENABLED(HANDOFF)) {
+ int ret;
+
+ ret = setup_spl_handoff();
+ if (ret) {
+ puts(SPL_TPL_PROMPT "Cannot set up SPL handoff\n");
+ hang();
+ }
+ }
#if CONFIG_IS_ENABLED(BOARD_INIT)
spl_board_init();