mpc8569mds: fix consuming long time while relocating code.
The original code maps boot flash as non-cacheable region. When calling
relocate_code in flash to copy u-boot from flash to ddr, every loop copy command
is read from flash. The flash read speed will be the bottleneck, which consuming
long time to do this operation. To resovle this, map the boot flash as
write-through cache via tlb. And set tlb to remap the flash after code
executing in ddr, to confirm flash erase operation properly done.
Signed-off-by: Kai.Jiang <Kai.Jiang@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/board/freescale/mpc8569mds/tlb.c b/board/freescale/mpc8569mds/tlb.c
index 73dcc3e..f852fc3 100644
--- a/board/freescale/mpc8569mds/tlb.c
+++ b/board/freescale/mpc8569mds/tlb.c
@@ -1,5 +1,5 @@
/*
- * Copyright 2009 Freescale Semiconductor, Inc.
+ * Copyright 2009-2010 Freescale Semiconductor, Inc.
*
* (C) Copyright 2000
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
@@ -46,15 +46,20 @@
/* TLB 1 Initializations */
/*
- * TLBe 0: 64M Non-cacheable, guarded
+ * TLBe 0: 64M write-through, guarded
* Out of reset this entry is only 4K.
- * 0xfc000000 256K NAND FLASH (CS3)
- * 0xfe000000 32M NOR FLASH (CS0)
+ * 0xfc000000 32MB NAND FLASH (CS3)
+ * 0xfe000000 32MB NOR FLASH (CS0)
*/
+#ifdef CONFIG_NAND_SPL
SET_TLB_ENTRY(1, CONFIG_SYS_NAND_BASE, CONFIG_SYS_NAND_BASE,
MAS3_SX|MAS3_SW|MAS3_SR, MAS2_I|MAS2_G,
+ 0, 0, BOOKE_PAGESZ_1M, 1),
+#else
+ SET_TLB_ENTRY(1, CONFIG_SYS_NAND_BASE, CONFIG_SYS_NAND_BASE,
+ MAS3_SX|MAS3_SW|MAS3_SR, MAS2_W|MAS2_G,
0, 0, BOOKE_PAGESZ_64M, 1),
-
+#endif
/*
* TLBe 1: 256KB Non-cacheable, guarded
* 0xf8000000 32K BCSR