mx5: Mark lowlevel_init board-specific code
The mx5 lowlevel_init.S contains board-specific code based on the reference
design. Let's keep it since it avoids creating new lowlevel_init files and it
may be used by many boards. But add a config to make it optional in order not to
cause issues on boards not following this part of the reference design.
Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau@advansee.com>
Cc: Stefano Babic <sbabic@denx.de>
Cc: Matt Sealey <matt@genesi-usa.com>
Acked-by: Stefano Babic <sbabic@denx.de>
diff --git a/doc/README.imx5 b/doc/README.imx5
index f7eab7d..e08941e 100644
--- a/doc/README.imx5
+++ b/doc/README.imx5
@@ -15,3 +15,8 @@
mode), which causes the effect of this failure to be much lower (in terms
of frequency deviation), avoiding system failure, or at least decreasing
the likelihood of system failure.
+
+1.2 CONFIG_SYS_MAIN_PWR_ON: Trigger MAIN_PWR_ON upon startup.
+ This option should be enabled for boards having a SYS_ON_OFF_CTL signal
+ connected to GPIO1[23] and triggering the MAIN_PWR_ON signal like in the
+ reference designs.