Move eSDHC adapter card identification to board files
The eSDHC adapter card identification and multiplexing configuration
through FPGA had been implemented in both common mmc driver and
fsl_esdhc driver. However it is proper to move these code to board
files and do it during board initialization. The FPGA registers are
also board specific.
This patch is to move eSDHC adapter card identification and
multiplexing configuration from mmc driver to specific board files.
And the option CONFIG_FSL_ESDHC_ADAPTER_IDENT is no longer needed.
Signed-off-by: Yangbo Lu <yangbo.lu@nxp.com>
[Rebased, Removed T1040QDS change as board does not exist]
Signed-off-by: Priyanka Jain <priyanka.jain@nxp.com>
diff --git a/drivers/mmc/mmc_private.h b/drivers/mmc/mmc_private.h
index 35170d0..a0900e8 100644
--- a/drivers/mmc/mmc_private.h
+++ b/drivers/mmc/mmc_private.h
@@ -1,6 +1,7 @@
/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Copyright 2008,2010 Freescale Semiconductor, Inc
+ * Copyright 2020 NXP
* Andy Fleming
*
* Based (loosely) on the Linux code
@@ -16,9 +17,6 @@
int mmc_poll_for_busy(struct mmc *mmc, int timeout);
int mmc_set_blocklen(struct mmc *mmc, int len);
-#ifdef CONFIG_FSL_ESDHC_ADAPTER_IDENT
-void mmc_adapter_card_type_ident(void);
-#endif
#if CONFIG_IS_ENABLED(BLK)
ulong mmc_bread(struct udevice *dev, lbaint_t start, lbaint_t blkcnt,