arm: Reduce the scope of lowlevel_init()
This function has grown into something of a monster. Some boards are setting
up a console and DRAM here in SPL. This requires global_data which should be
set up in one place (crt0.S).
There is no need for SPL to use s_init() for anything since board_init_f()
is called immediately afterwards.
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/arch/arm/cpu/armv7/lowlevel_init.S b/arch/arm/cpu/armv7/lowlevel_init.S
index f1aea05..427b0b1 100644
--- a/arch/arm/cpu/armv7/lowlevel_init.S
+++ b/arch/arm/cpu/armv7/lowlevel_init.S
@@ -17,10 +17,17 @@
ENTRY(lowlevel_init)
/*
- * Setup a temporary stack
+ * Setup a temporary stack. Global data is not available yet.
*/
ldr sp, =CONFIG_SYS_INIT_SP_ADDR
bic sp, sp, #7 /* 8-byte alignment for ABI compliance */
+#ifdef CONFIG_DM
+ mov r9, #0
+#else
+ /*
+ * Set up global data for boards that still need it. This will be
+ * removed soon.
+ */
#ifdef CONFIG_SPL_BUILD
ldr r9, =gdata
#else
@@ -28,13 +35,24 @@
bic sp, sp, #7
mov r9, sp
#endif
+#endif
/*
* Save the old lr(passed in ip) and the current lr to stack
*/
push {ip, lr}
/*
- * go setup pll, mux, memory
+ * Call the very early init function. This should do only the
+ * absolute bare minimum to get started. It should not:
+ *
+ * - set up DRAM
+ * - use global_data
+ * - clear BSS
+ * - try to start a console
+ *
+ * For boards with SPL this should be empty since SPL can do all of
+ * this init in the SPL board_init_f() function which is called
+ * immediately after this.
*/
bl s_init
pop {ip, pc}