86xx: Allow for fewer DDR slots per memory controller.
As a direct correlation exists between DDR DIMM slots
and SPD EEPROM addresses used to configure them, use
the individually defined SPD_EEPROM_ADDRESS* values to
determine if a DDR DIMM slot should have its SPD
configuration read or not.
Effectively, this now allows for 1 or 2 DIMM slots
per memory controller.
Signed-off-by: Jon Loeliger <jdl@freescale.com>
diff --git a/cpu/mpc86xx/spd_sdram.c b/cpu/mpc86xx/spd_sdram.c
index f37ab43..059097f 100644
--- a/cpu/mpc86xx/spd_sdram.c
+++ b/cpu/mpc86xx/spd_sdram.c
@@ -948,19 +948,25 @@
* Read both dimm slots and decide whether
* or not to enable this controller.
*/
- memset((void *)&spd1,0,sizeof(spd1));
- memset((void *)&spd2,0,sizeof(spd2));
+ memset((void *)&spd1, 0, sizeof(spd1));
+ memset((void *)&spd2, 0, sizeof(spd2));
if (ddr_num == 1) {
CFG_READ_SPD(SPD_EEPROM_ADDRESS1,
0, 1, (uchar *) &spd1, sizeof(spd1));
+#if defined(SPD_EEPROM_ADDRESS2)
CFG_READ_SPD(SPD_EEPROM_ADDRESS2,
0, 1, (uchar *) &spd2, sizeof(spd2));
+#endif
} else {
+#if defined(SPD_EEPROM_ADDRESS3)
CFG_READ_SPD(SPD_EEPROM_ADDRESS3,
0, 1, (uchar *) &spd1, sizeof(spd1));
+#endif
+#if defined(SPD_EEPROM_ADDRESS4)
CFG_READ_SPD(SPD_EEPROM_ADDRESS4,
0, 1, (uchar *) &spd2, sizeof(spd2));
+#endif
}
/*
@@ -1105,21 +1111,25 @@
{
int memsize_ddr1_dimm1 = 0;
int memsize_ddr1_dimm2 = 0;
+ int memsize_ddr1 = 0;
+ unsigned int law_size_ddr1;
+ volatile immap_t *immap = (immap_t *)CFG_IMMR;
+ volatile ccsr_ddr_t *ddr1 = &immap->im_ddr1;
+ volatile ccsr_local_mcm_t *mcm = &immap->im_local_mcm;
+
+#if (CONFIG_NUM_DDR_CONTROLLERS > 1)
int memsize_ddr2_dimm1 = 0;
int memsize_ddr2_dimm2 = 0;
- int memsize_total = 0;
- int memsize_ddr1 = 0;
int memsize_ddr2 = 0;
+ unsigned int law_size_ddr2;
+#endif
+
unsigned int ddr1_enabled = 0;
unsigned int ddr2_enabled = 0;
- unsigned int law_size_ddr1;
- unsigned int law_size_ddr2;
- volatile immap_t *immap = (immap_t *)CFG_IMMR;
- volatile ccsr_local_mcm_t *mcm = &immap->im_local_mcm;
+ int memsize_total = 0;
#ifdef CONFIG_DDR_INTERLEAVE
unsigned int law_size_interleaved;
- volatile ccsr_ddr_t *ddr1 = &immap->im_ddr1;
volatile ccsr_ddr_t *ddr2 = &immap->im_ddr2;
memsize_ddr1_dimm1 = spd_init(SPD_EEPROM_ADDRESS1,
@@ -1194,9 +1204,11 @@
(unsigned int)memsize_total * 1024*1024);
memsize_total += memsize_ddr1_dimm1;
+#if defined(SPD_EEPROM_ADDRESS2)
memsize_ddr1_dimm2 = spd_init(SPD_EEPROM_ADDRESS2,
1, 2,
(unsigned int)memsize_total * 1024*1024);
+#endif
memsize_total += memsize_ddr1_dimm2;
/*