Blackfin: split cache handling out of dma_memcpy()
Creating a new dma_memcpy() function that skips all cache checks allows us
to use the function in very early init where the cache is not yet setup.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/lib_blackfin/string.c b/lib_blackfin/string.c
index ab71285..2a56910 100644
--- a/lib_blackfin/string.c
+++ b/lib_blackfin/string.c
@@ -134,7 +134,7 @@
* Perhaps we should detect that ? Nowhere do we actually
* use dma memcpy for those types of lengths though ...
*/
-static void *dma_memcpy(void *dst, const void *src, size_t count)
+void dma_memcpy_nocache(void *dst, const void *src, size_t count)
{
/* Scratchpad cannot be a DMA source or destination */
if (((unsigned long)src >= L1_SRAM_SCRATCH &&
@@ -143,10 +143,9 @@
(unsigned long)dst < L1_SRAM_SCRATCH_END))
hang();
- if (dcache_status())
- blackfin_dcache_flush_range(src, src + count);
-
- bfin_write_MDMA_D0_IRQ_STATUS(DMA_DONE | DMA_ERR);
+ bfin_write_MDMA_S0_CONFIG(0);
+ bfin_write_MDMA_D0_CONFIG(0);
+ bfin_write_MDMA_D0_IRQ_STATUS(DMA_RUN | DMA_DONE | DMA_ERR);
/* Copy sram functions from sdram to sram */
/* Setup destination start address */
@@ -165,13 +164,23 @@
/* Enable source DMA */
bfin_write_MDMA_S0_CONFIG(DMAEN);
- SSYNC();
bfin_write_MDMA_D0_CONFIG(WNR | DMAEN);
+ SSYNC();
while (bfin_read_MDMA_D0_IRQ_STATUS() & DMA_RUN)
- bfin_write_MDMA_D0_IRQ_STATUS(bfin_read_MDMA_D0_IRQ_STATUS() | DMA_DONE | DMA_ERR);
- bfin_write_MDMA_D0_IRQ_STATUS(bfin_read_MDMA_D0_IRQ_STATUS() | DMA_DONE | DMA_ERR);
+ continue;
+
+ bfin_write_MDMA_D0_IRQ_STATUS(bfin_read_MDMA_D0_IRQ_STATUS() | DMA_RUN | DMA_DONE | DMA_ERR);
+ bfin_write_MDMA_D0_CONFIG(0);
+ bfin_write_MDMA_S0_CONFIG(0);
+}
+void *dma_memcpy(void *dst, const void *src, size_t count)
+{
+ if (dcache_status())
+ blackfin_dcache_flush_range(src, src + count);
+
+ dma_memcpy_nocache(dst, src, count);
if (icache_status())
blackfin_icache_flush_range(dst, dst + count);