ARM: dts: imx53-qsb: Describe the esdhc1 card detect pin
The micro SD card slot uses GPIO3_13 as card detect pin, so describe
it in the devicetree.
This was noticed when converting imx53-qsb board to driver model
in U-Boot as the micro SD card was not getting detected.
After this change it is possible to load the dtb and zImage
from the SD card and boot Linux.
Signed-off-by: Fabio Estevam <festevam@gmail.com>
diff --git a/arch/arm/dts/imx53-qsb-common.dtsi b/arch/arm/dts/imx53-qsb-common.dtsi
index 9b4efcd..fe42440 100644
--- a/arch/arm/dts/imx53-qsb-common.dtsi
+++ b/arch/arm/dts/imx53-qsb-common.dtsi
@@ -142,6 +142,7 @@
&esdhc1 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_esdhc1>;
+ cd-gpios = <&gpio3 13 GPIO_ACTIVE_LOW>;
status = "okay";
};
@@ -209,6 +210,7 @@
MX53_PAD_SD1_DATA3__ESDHC1_DAT3 0x1d5
MX53_PAD_SD1_CMD__ESDHC1_CMD 0x1d5
MX53_PAD_SD1_CLK__ESDHC1_CLK 0x1d5
+ MX53_PAD_EIM_DA13__GPIO3_13 0xe4
>;
};