* Patch by Pierre Aubert, 26 Feb 2004
add IDE support for MPC5200
* Patch by Masami Komiya, 26 Feb 2004:
add autoload via NFS
* Patch by Stephen Williams
Use of CONFIG_SERIAL_SOFTWARE_FIFO in board.c consistent with uses
elsewhere in the source.
diff --git a/include/configs/IceCube.h b/include/configs/IceCube.h
index 1dc9925..1d4daa7 100644
--- a/include/configs/IceCube.h
+++ b/include/configs/IceCube.h
@@ -81,6 +81,10 @@
#endif
+/* Partitions */
+#define CONFIG_MAC_PARTITION
+#define CONFIG_DOS_PARTITION
+
/* USB */
#if 1
#define CONFIG_USB_OHCI
@@ -94,8 +98,12 @@
/*
* Supported commands
*/
-#define CONFIG_COMMANDS (CONFIG_CMD_DFL | ADD_PCI_CMD | \
- CFG_CMD_I2C | CFG_CMD_EEPROM | \
+#define CONFIG_COMMANDS (CONFIG_CMD_DFL | \
+ CFG_CMD_EEPROM | \
+ CFG_CMD_FAT | \
+ CFG_CMD_I2C | \
+ CFG_CMD_IDE | \
+ ADD_PCI_CMD | \
ADD_USB_CMD)
/* this must be included AFTER the definition of CONFIG_COMMANDS (if any) */
@@ -293,4 +301,36 @@
#define CFG_RESET_ADDRESS 0xff000000
+/*-----------------------------------------------------------------------
+ * IDE/ATA stuff Supports IDE harddisk
+ *-----------------------------------------------------------------------
+ */
+
+#undef CONFIG_IDE_8xx_PCCARD /* Use IDE with PC Card Adapter */
+
+#undef CONFIG_IDE_8xx_DIRECT /* Direct IDE not supported */
+#undef CONFIG_IDE_LED /* LED for ide not supported */
+
+#define CONFIG_IDE_RESET /* reset for ide supported */
+#define CONFIG_IDE_PREINIT
+
+#define CFG_IDE_MAXBUS 1 /* max. 1 IDE bus */
+#define CFG_IDE_MAXDEVICE 1 /* max. 1 drive per IDE bus */
+
+#define CFG_ATA_IDE0_OFFSET 0x0000
+
+#define CFG_ATA_BASE_ADDR MPC5XXX_ATA
+
+/* Offset for data I/O */
+#define CFG_ATA_DATA_OFFSET (0x0060)
+
+/* Offset for normal register accesses */
+#define CFG_ATA_REG_OFFSET (CFG_ATA_DATA_OFFSET)
+
+/* Offset for alternate registers */
+#define CFG_ATA_ALT_OFFSET (0x005c)
+
+/* Interval between registers */
+#define CFG_ATA_STRIDE 4
+
#endif /* __CONFIG_H */
diff --git a/include/configs/eXalion.h b/include/configs/eXalion.h
index 5ebc7a9..a014c7c 100644
--- a/include/configs/eXalion.h
+++ b/include/configs/eXalion.h
@@ -50,13 +50,13 @@
#error #### Specific type of MPC824x must be defined (i.e. CONFIG_MPC8240)
#endif
/* older kernels need clock in MHz newer in Hz */
- /* #define CONFIG_CLOCKS_IN_MHZ 1 *//* clocks passsed to Linux in MHz */
+ /* #define CONFIG_CLOCKS_IN_MHZ 1 */ /* clocks passsed to Linux in MHz */
#undef CONFIG_CLOCKS_IN_MHZ
#define CONFIG_BOOTDELAY 10
- /*#define CONFIG_DRAM_SPEED 66 *//* MHz */
+ /*#define CONFIG_DRAM_SPEED 66 */ /* MHz */
#define CONFIG_COMMANDS ( CONFIG_CMD_DFL | \
CFG_CMD_FLASH | \
@@ -230,7 +230,7 @@
#define CONFIG_SYS_CLK_FREQ 33333333 /* external frequency to pll */
#define CONFIG_PLL_PCI_TO_MEM_MULTIPLIER 2 /* for MPC8240 only */
- /*#define CONFIG_133MHZ_DRAM 1 *//* For 133 MHZ DRAM only !!!!!!!!!!! */
+ /*#define CONFIG_133MHZ_DRAM 1 */ /* For 133 MHZ DRAM only !!!!!!!!!!! */
#if defined (CONFIG_MPC8245)
/* Bit-field values for PMCR2. */