ahci: Don't start command DMA engine before buffers are set
The DMA/FIS buffers are set in ahci_port_start() which is called
after ahci_host_init(). So don't start the DMA engine here
(i.e. don't set FIS_RX)
This fixes the following error at kernel boot on OMAP platforms (e.g. DRA7x)
WARNING: CPU: 0 PID: 0 at drivers/bus/omap_l3_noc.c:147 l3_interrupt_handler+0x260/0x358()
44000000.ocp:L3 Custom Error: MASTER SATA TARGET GPMC (Idle): Data Access in User mode during Functional access
Signed-off-by: Roger Quadros <rogerq@ti.com>
diff --git a/drivers/block/ahci.c b/drivers/block/ahci.c
index dce99ad..a93a8e1 100644
--- a/drivers/block/ahci.c
+++ b/drivers/block/ahci.c
@@ -229,7 +229,6 @@
* already be on in the command register.
*/
cmd = readl(port_mmio + PORT_CMD);
- cmd |= PORT_CMD_FIS_RX;
cmd |= PORT_CMD_SPIN_UP;
writel_with_flush(cmd, port_mmio + PORT_CMD);